Here is a few flights that were never going to be made into a video. On the day the wind had picked up quite a bit so me and CamSump had
As the cold weather has set in I have not been flying much so I decided to look through some old footage and found this day in the woods
Guest speaker at our local library asked me to bring my Arduino powered devices for 'show and tell.'
Greets from Holland
After 2min of fly'ing didn't see much trough the FATSHARK
kept raining and raining in Holland
Last flight, the building is nearly finished.
HK Talon carbon frame
KK2 FCB 1.6 firmware
Turnigy 2200mAh 3S 30C
does the configuration of your motors allow for more thrust or just better control? also, do the motors on the same arm spin in the same direction or
Yes, I found that it was best to keep the motors mounted as rigid as possible, but also use the mass of the battery to dampen the vibration. I have rigid
My JST-SH connector parts arrived yesterday. I pried out the RCA jacks, soldered up the connectors, plugged it in, powered
Yep, I'm noticing vibration through the camera. At the rate that I'm still breaking props, I'm reluctant to spend money on nice ones. I'm able to get
Good to be back. Upgraded my typhoon as well, used the motors from the hex here so now instead of 2212/13 they are now 2820/14. Going to use it as a stunt
Welcome back safe. We have missed you while you were away somewhere ... 16lbs. You never were one to go light heh.
Sent from my SGH-T999
Time to accessorize! The video transmitter, camera, OSD, GPS receiver, sonar, power conditioner and BEC are here. I'm also planning to power the AQ32
Got back from deployment about a week ago and went strait to work. Got the new motors, props, 3rd axis, and vibration plate installed. I also just put
I also started FPV with the quad I learnt to fly on. However I had alot of vibration issues when I mounted my camera on the frame (X525). In order to
Just because your ESCs aren't opto isolated (in which case they wouldn't power your AQ32v2 anyway) doesn't mean you can't get a separate BEC. Honestly