Here is a few flights that were never going to be made into a video. On the day the wind had picked up quite a bit so me and CamSump had
As the cold weather has set in I have not been flying much so I decided to look through some old footage and found this day in the woods
Guest speaker at our local library asked me to bring my Arduino powered devices for 'show and tell.'
Greets from Holland
After 2min of fly'ing didn't see much trough the FATSHARK
kept raining and raining in Holland
Last flight, the building is nearly finished.
HK Talon carbon frame
KK2 FCB 1.6 firmware
Turnigy 2200mAh 3S 30C
I think that with my previous Quad the largest amount of experience I gained is
with regard to crashing.
I found that the Cyclone
No it doesn't result in double throust because the lower props spin in the prop wash of the top motors. So you loose some efficiency but you can experiment
so I can't say that 8 motors in that configuration allow for double the thrust of 4?
They definitely allow more thrust but I can't say exactly how much additional thrust it gives. But I can say that it is definitely more responsive to
That makes sense.
I think I've got it working on power-up now. I'll open a
does the configuration of your motors allow for more thrust or just better control? also, do the motors on the same arm spin in the same direction or
Yes, I found that it was best to keep the motors mounted as rigid as possible, but also use the mass of the battery to dampen the vibration. I have rigid
My JST-SH connector parts arrived yesterday. I pried out the RCA jacks, soldered up the connectors, plugged it in, powered
Yep, I'm noticing vibration through the camera. At the rate that I'm still breaking props, I'm reluctant to spend money on nice ones. I'm able to get
Good to be back. Upgraded my typhoon as well, used the motors from the hex here so now instead of 2212/13 they are now 2820/14. Going to use it as a stunt